- Q If you owned the company, would you do it the way you are proposing?
- Q A person is wearing glasses of power -2.5. It indicates that the person is _____?
- Q What are adhoc reports and static reports?
- Q what is the purpose of “Protect and EndProtect”?.
- Q TCP/IP hdr checksum : what method is used ?
- Q What is Christmas Disease
- Q On your OSPF network, routers CK1 and CK2 belong to the same Ethernet network. However, they are unable to establish an adjacency over this link. While troubleshooting this problem, you issue the "show ip ospf interface Ethernet 0" command on each router. The output from these commands is displayed below: CK1 : Ethernet is up, line protocol is up Internet address 192.168.1.2/24, Area 0 Process ID 1, Router ID 192.168.31.33, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 192.168.31.33, Interface address 192.168.1.2 No backup designated router on this network Time intervals configured, Hello 5, Dead 20, Wait 20, Retransmit 5 CK2 : Ethernet0 is up, line protocol is up Internet address 192.168.1.1/24, Area 0 Process ID 2, Router ID 192.168.31.11, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 192.168.31.11, Interface address 192.168.1.1 No backup designated router on this network Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 What is the underlying cause of the routers failing to become adjacent? A. The OSPF area is misconfigured. B. The priority on CK2 should be set lower. C. The cost on CK2 should be set lower. D. The hello and dead timers are misconfigured. E. You need to add a backup designated router to the network. F. The OSPF process ID numbers do not match.
- Q The Indian state which was known as Brahmarshidesh in ancient times:
- Q How is qlikview 11 different from qlikview 10?
- Q IN CLOUD COMPUTNG, WHAT ARE THE DIFFERENT TYPES OF LAYERS?
- Q When was the first Olympics organized