- Set up an additional poller on the Network Manager server if one poller is not sufficient to handle your network load.
- To set up an additional poller for the monitoring system, you must add a record to the NCMonitor Poller table, which adds the record to the Monitor Policy editor.- The ncp_poller process creates the record in the poller table and then exits.- The poller is automatically installed when you install Network Manager. Complete the following steps to register a new instance of the poller and automatically start the poller.1. On the system where the poller will run, register the poller by entering the following command.ncp_poller -domain domain_name -register -name poller_name2. Edit the CtrlServicesDOMAIN.cfg file.a. Locate the entry for the ncp_poller process.b. Copy the entry and change the -name parameter to match the name you used to register the poller.c. Save and close the file.3. Restart the ncp_ctrl process with the specified domain. The ncp_ctrl process restarts all running ncp_ processes, including the new poller   _{Your Comment}